Home > News > Content
Add: No.3, Tianyang 4th Road, Datianyang Industrial Area, Songgang Town, Baoan District, Shenzhen City, China
Tel: +86-755-33925289
Fax: +86-755-33925292
Mob: +8613128892605
Contacts: Hikin
Email: hikinsong@foxmail.com

Socket Purchase Guide

Shenzhen GEO Technology Co.,Ltd | Updated: Sep 07, 2017

Switch socket panel prices vary widely, the price from a few dollars more than ten dollars, to tens of dollars on the hundred dollars, there are, and the product does not seem much difference, but in fact the quality difference is very large. According to statistics, more than 1,500 domestic production switch, socket electrical accessories manufacturers, the relevant state departments issued by the production license only 1/3 more than Many manufacturers in the publicity to exaggerate the data, to deceive consumers, according to the actual 2005 State Bureau of Technical Supervision data show: switch socket products qualified rate of industry sampling rate is very low, in 2005 only about 60%. These poor socket switches are one of the important causes of home fires. So the switch socket selection must also be cautious.

Socket Selection Guide:

1, look at the protection of the door, with a screwdriver or a small key poke the side of the two holes and three holes below the hole. With the effort, poke into the unilateral protection door is equal to no. This outlet is obviously not safe enough.

2, followed by copper materials used. If you see through the jack is bright yellow, then give it directly. Brass rust easily, soft texture, a long time contact, conductive performance will decline. If the copper color is purple is better, more tough copper, not easy to rust. Do not see directly, but also generally open to see. Many sockets are jack here with copper, which are all with brass, the same easy to rust. Even with copper, there are high points. Most of the brand of copper pieces are several pieces of stitching, with rivets interface, so that the interface will be hot, affecting the conductive. Technology comparison of the current brand will use the whole piece of copper inside the copper pieces, so that a lot of improved conductivity.

3, the third, look at the distance between the two and three plug it Some products did not consider so much, two holes and three holes closer, inserted three holes, two holes on the variable furnishings, because the plug is large, the place accounted for. These questions must be considered when buying a socket.

4, in addition, the power of household appliances is now growing, the switch load requirements are relatively high, especially in the electrical power of the moment (a lot of low-quality switch is energized when the instantaneous large current burned). Good switch should be able to pass more than 16A current, and ordinary can only pass 10A current.